D1 board already fails its own 100 pF line limit on main, and no test runs the check on it While sizing I2C/SPI drive strength from extracted line capacitance, the team found 7 of 8 I2C lines on D1 at 87.8 to 119.6 pF against its declared 100 pF, and nothing in CI runs extract on that board. The IMU fixture has no KiCad symbol, so extraction gives it no capacitance at all. The MCU's pin capacitance is a typical value only. Datasheet numbers, library symbols and the board each hold a piece of the answer.
Silent failure reported against aethelgard (ClearForge-LLC)
What engineers report
A silent failure reported against aethelgard (ClearForge-LLC): reports success, or uses stale data, while the result is wrong or missing.
Recorded mode: validation / failure
Analyst note
From the Grok pain-radar digests, Nov 14-15 2026 (Nov 14 8:41 PM ET through Nov 15 1:41 AM ET digests plus the Haitch edition). Verified live 2026-11-15: issue/PR read; title and state confirmed.
What it costs a team
Modeled annual cost
$30,000
For a team of 5
Prototype delay
3 days
Modeled schedule slip per occurrence
Time lost
240 min
Per engineer per month, about 1 incidents
How the cost is modeled
240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000
A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.
Engineering tools that address it
No engineering tool profile lists this error yet. Browse tools that connect to aethelgard (ClearForge-LLC).
Evidence
More recurring errors in aethelgard (ClearForge-LLC)
- A vacuous proof was enough to pass prove, and the reader had a critical bypass and must now tokenize exactly as KiCad does.Electronics & PCB · impact 66
- Agent-run spike on off-board connectors: the work order assumed JST GH, the Pixhawk DS-009 spec says the debug ports are SH. A device-less SPI bus produced three one-pin nets, and the tool's validate, solve and emit all exited 0. KiCad would flag each one, but the KiCad gate run was blocked, so nothing caught it.Electronics & PCB · impact 66
- ClearForge's aethelgard spike ran KiCad 10.0.7 at 4 and 6 layers and found the stackup is inert: KiCad needs no stackup, the gate discards the setup block, and DRC and the Gerbers ignore it. The team now requires a board section with layers, the stackup as bounds with sources, and pulls prepreg thicknesses from JLCPCB and OSH Park pages. The stackup is the one place board, fab and SI meet, and the ECAD file treats it as a comment.Electronics & PCB · impact 66
- Rule RUL-03 says the gate supplies every file that carries DRC rules from the spec and never uses the emitter's copies; the same PR notes Renode's STM32F7 I2C model has no I2C errors at all, so simulated firmware can't hit a NACK.Electronics & PCB · impact 66
Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.