On a mains PSU board, bulk sat on T1's dotted primary pin and D5's anode on the dotted secondary pin. That makes it a forward converter, so VDD heads to about 103 V against the controller's 38 V limit. "erc, verify, verify_release and attest build all passed. An independent cold review found it by reading the Würth drawing and TI's reference schematic pin by pin." The same review found the 12 V winding on the wrong pins (5 turns instead of 7). The ask is for transformer symbols to carry dots and a turns table, and for a check that compares wiring with the declared topology.