importing a .f3d file into Mitcad dropped every constraint in a sketch (including dimensions driven by parameters and formulas) because of one or two bad constraints in it.
Silent failure reported against Mitcad (mitcad)
What engineers report
A silent failure reported against Mitcad (mitcad): reports success, or uses stale data, while the result is wrong or missing.
Recorded mode: agent / silent failure
Analyst note
From the Grok pain-radar digest, Oct 25-26 2026 (Oct 25 daytime to Oct 26 morning slots). Verified live 2026-10-26: issue/PR read on GitHub; title and state confirmed.
What it costs a team
Modeled annual cost
$30,000
For a team of 5
Prototype delay
3 days
Modeled schedule slip per occurrence
Time lost
240 min
Per engineer per month, about 1 incidents
How the cost is modeled
240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000
A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.
Engineering tools that address it
No engineering tool profile lists this error yet. Browse tools that connect to Mitcad (mitcad).
Evidence
More recurring errors in Mitcad (mitcad)
- A mitCAD import of an Inventor design via FreeCAD turned hole features into plain geometry, losing diameter, depth, and counterbore type.Mechanical · impact 66
- A user says switching to MitCad would be easier if it could write .FCStd, so they can still use FreeCAD's FEA and other features MitCad does not have.Mechanical · impact 66
- MitCAD fillets on the same import failed with no error, produced self-intersecting geometry, or broke the timeline when an upstream sketch changed.Mechanical · impact 66
- The part shows fine on screen, but editing the CylinderPlate sketch shows no edges and no holes, so the user can't change the hole size they needed to change. The import gave no warning. Geometry came across, design intent didn't.Mechanical · impact 66
Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.