The TPS25751 USB-PD controller's schematic models every power terminal separately, while its PCB footprint groups them into shared lands. KiCad reports seven parity conflicts that remain, and the owner wants each one resolved or dispositioned without concealing electrical differences, plus a review of the VCONN supply that is currently left unpowered. The schematic and the footprint describe the same chip two different ways, and somebody has to decide which one is true.
Wrong design output reported against 32-bit-micro-processor (vivasaayi)
What engineers report
A wrong design output reported against 32-bit-micro-processor (vivasaayi): produces incorrect geometry, routing, values or parts.
Recorded mode: validation / failure
Analyst note
From the Grok pain-radar digests, Nov 13-14 2026 (Nov 13 10:41 AM ET through Nov 14 7:41 AM ET digests plus the Haitch editions). Verified live 2026-11-14: issue/PR read; title and state confirmed.
What it costs a team
Modeled annual cost
$30,000
For a team of 5
Prototype delay
3 days
Modeled schedule slip per occurrence
Time lost
240 min
Per engineer per month, about 1 incidents
How the cost is modeled
240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000
A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.
Engineering tools that address it
No engineering tool profile lists this error yet. Browse tools that connect to 32-bit-micro-processor (vivasaayi).
Evidence
More recurring errors in 32-bit-micro-processor (vivasaayi)
- An inventory found that 87 of 88 checked-in KiCad module projects with a top-level PCB have no ERC section in the project file. Only the SHT31 pilot does. The generator copies a template that has explicit ERC config, so somewhere between schematic and PCB generation the settings get dropped. On one board the generator deliberately changes an ERC matrix pair, the saved project does not have it, and KiCad 10.0.8 reports two errors. The author is careful to say the cause is not proven yet.Electronics & PCB · impact 66
- The schematic and the canonical PCB both wire the ECP5's Master SPI chip select to flash IO3, while a different FPGA pin reaches flash CS#. The header says do not fabricate or attempt boot. The corrected schematic and routing exist only as unapproved trials, not merged into the host design, and the fix touches schematic, generator, PCB, pinout, FPGA toolchain and bitstream boot mode at once. A 62 MHz flash clock setting is flagged as unmeasured. Hardware, FPGA config and firmware boot all depend on one pin assignment nobody caught until now.Simulation & verification · impact 66
- The shared readiness report and fab exporter "could report misleading success, so existing fab-ready counts cannot yet be used as release evidence." The batch checker had hard-coded paths and returned success for failing targets. The fix list is long: fail closed on ERC and DRC, fresh reports per run, build packages in a clean directory so stale artifacts cannot pass, and keep MPN and DNP straight in the BOM export. The fixes are tested only against a simulated KiCad CLI, because kicad-cli is not installed where the work is happening.Electronics & PCB · impact 66
Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.