The schematic and the canonical PCB both wire the ECP5's Master SPI chip select to flash IO3, while a different FPGA pin reaches flash CS#. The header says do not fabricate or attempt boot. The corrected schematic and routing exist only as unapproved trials, not merged into the host design, and the fix touches schematic, generator, PCB, pinout, FPGA toolchain and bitstream boot mode at once. A 62 MHz flash clock setting is flagged as unmeasured. Hardware, FPGA config and firmware boot all depend on one pin assignment nobody caught until now.

Wrong design output reported against 32-bit-micro-processor (vivasaayi)

32-bit-micro-processor (vivasaayi)Simulation & verificationWrong design outputMedium confidence

What engineers report

A wrong design output reported against 32-bit-micro-processor (vivasaayi): produces incorrect geometry, routing, values or parts.

Recorded mode: validation / failure

Analyst note

From the Grok pain-radar digests, Nov 13-14 2026 (Nov 13 10:41 AM ET through Nov 14 7:41 AM ET digests plus the Haitch editions). Verified live 2026-11-14: issue/PR read; title and state confirmed.

What it costs a team

Modeled annual cost

$30,000

For a team of 5

Prototype delay

3 days

Modeled schedule slip per occurrence

Time lost

240 min

Per engineer per month, about 1 incidents

How the cost is modeled

240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000

A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.

Engineering tools that address it

No engineering tool profile lists this error yet. Browse tools that connect to 32-bit-micro-processor (vivasaayi).

Evidence

  1. 1vivasaayi/32-bit-micro-processor Issue #128: ECP5 boot blocker: Master SPI chip select wired to flash IO3github.com

More recurring errors in 32-bit-micro-processor (vivasaayi)

See all 4 32-bit-micro-processor (vivasaayi) errors

Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.