A technical review of a handheld ESP32-S3 build found the docs, pinout and firmware config disagreeing: GPIO 0 is the power button but low at reset drops the S3 into the serial bootloader, GPIO 47 is a button in bmo.ini but missing from the pin menu, and the battery moved from selected to candidate, not approved. There is still no measured current draw.
Recurring agent failure issue in d-BMO-body (resende-g)
What engineers report
A recurring agent failure problem in d-BMO-body (resende-g) that mostly hits the electrical engineer.
Failure pattern: validation / failure
Analyst note
From the Grok pain-radar digests, Nov 9-10 2026 (Nov 9 7:41 AM ET through Nov 10 7:41 AM ET digests plus the Haitch editions). Verified live 2026-11-10: issue/PR read; title and state confirmed.
What it costs a team
Modeled annual cost
$30,000
For a team of 5
Prototype delay
3 days
Modeled schedule slip per occurrence
Time lost
240 min
Per engineer per month, about 1 incidents
How the cost is modeled
240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000
A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.
Engineering tools that address it
No engineering tool profile lists this error yet. Browse tools that connect to d-BMO-body (resende-g).
Evidence
Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.