Same project as finding 1: the PR swapped four hand-typed enclosure notes for computed ones, and two turned out to describe geometry that had changed underneath them without anyone deciding it should. The edge ledger had an entry for C7, a part that is not on the board, and once the ledger audited itself, all seven of its entries were dead. The brace README said the rails back the four solder tabs, which was wrong.
Silent failure reported against solar-business-card (devinhorowitz)
What engineers report
A silent failure reported against solar-business-card (devinhorowitz): reports success, or uses stale data, while the result is wrong or missing.
Recorded mode: validation / failure
Analyst note
From the Grok pain-radar digests, Nov 13-14 2026 (Nov 13 10:41 AM ET through Nov 14 7:41 AM ET digests plus the Haitch editions). Verified live 2026-11-14: issue/PR read; title and state confirmed.
What it costs a team
Modeled annual cost
$30,000
For a team of 5
Prototype delay
3 days
Modeled schedule slip per occurrence
Time lost
240 min
Per engineer per month, about 1 incidents
How the cost is modeled
240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000
A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.
Engineering tools that address it
No engineering tool profile lists this error yet. Browse tools that connect to solar-business-card (devinhorowitz).
Evidence
More recurring errors in solar-business-card (devinhorowitz)
- An independent tool (SolidCraft) measured the committed enclosure solids and found six problems: every STEP and STL is the mirror image of the part, all four supercaps sit 0.17 to 0.375 mm inside their mount bosses, both braces are 0.20 mm wider than their cavities, and one shell has 804 sliver faces that SolidCraft refuses to open. Every gate the repo already had passed these files, because it compared fit_rules against itself, and the fix gates the emitted STL instead. The author says nothing in enclosure/ should go to a shop or printer from main, and the mirror question is still open.Mechanical · impact 74
- DigiKey sold through 490 units of C11's Murata cap within hours of a part swap; Mouser had 17,858. Moving the supplier part number tripped the repo's own consistency check, because Mouser abbreviates long Murata numbers. Rather than loosen the matcher, which had caught two real wrong-part failures before, the author added a ledger of live-verified MPN/P/N pairs and self-tests that keep the old failures out of it.Electronics & PCB · impact 66
Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.