cad (evgunter) errors

3 recurring problems engineers report in cad (evgunter), ranked by impact.

#155 by errors trackedVerificationMCAD

Recurring cad (evgunter) errors, by impact

  1. 1A clearance is a requirement, not a measurement. Clearances become assertions in the document, checked by one fused sweep, instead of numbers someone reads off.Verification · Agent failure · 1 report66
  2. 2A STEP-export kernel check went red on main because the test sat in a slow CI set that neither change triggered. A committed volume value for cut_cylinder (1022.3704888604841) went stale when the kernel moved it to 1022.370482199146. The test was meant to be fast, but it had been in the slow set since Oct 16, so neither gate ran it.MCAD · Agent failure · 1 report66
  3. 3Triaging nightly failures found the 11-08 green run had skipped every job, so baselines had to come from older nightlies and local before/after builds. The rustdoc gate also stops at its first failing crate, which masked other failures. A nightly success that was vacuous.MCAD · Agent failure · 1 report66

How it fails

  1. Agent failure3

Sourced from public community reports. Costs and delays on individual entries are modeled estimates, not measurements.