easyeda-agent (zhoushoujianwork) errors

3 recurring problems engineers report in easyeda-agent (zhoushoujianwork), ranked by impact.

#164 by errors trackedECAD

Recurring easyeda-agent (zhoushoujianwork) errors, by impact

  1. 1An agent moving parts on a 468-component, four-layer board got 110 'success' returns, then the connector dropped and some moves never persisted; even at batches of five with save and readback, the tool warned the readback and DRC could be reading stale engine state.ECAD · Agent failure · 1 report74
  2. 2On a 4-layer 100 x 100 mm board with 6 mil clearance and 10/20 mil tracks, route-short and pcb check both read clearance as 235.6 mil and width as 393.7 mil, a factor of 39.37, so millimetres were converted to mil twice. Dry-run routed 0 segments and skipped all 104 jumps, and pcb check threw dozens of false clearance errors per run.ECAD · Agent failure · 1 report74
  3. 3On EasyEDA Pro 4.1.78, 'easyeda sch check' reports wire-contact errors between NET_A/NET_B and NET_B/NET_C on a page where those three wires sit 80 units apart and never touch. The schematic read shows three separate nets and the bridge check reports zero problems, and the named net pair shifts when labelled wires are added or removed, so the check is pairing the wrong wire segments.ECAD · Agent failure · 1 report74

How it fails

  1. Agent failure3

Engineering tools that address these errors

Sourced from public community reports. Costs and delays on individual entries are modeled estimates, not measurements.