gyropup (Valpatel) errors

4 recurring problems engineers report in gyropup (Valpatel), ranked by impact.

#127 by errors trackedMCADVerification

Recurring gyropup (Valpatel) errors, by impact

  1. 1mount.json still says the turret frame's origin is in the TM face although change D66 moved the turret 86 mm below it, so the real centre of mass is 135.2 mm above the face, not 49.2, and bolt load rises from 233 N to 637 N.MCAD · Agent failure · 1 report74
  2. 2The assembly guide and docs still carry the old upper-stop instruction while the CAD script authors +12/-25, and the exported step JSON drops some of what the recipes hold. There are no published releases to pin a build to, and checklists are stored per project, not per version.MCAD · Agent failure · 1 report74
  3. 3gyropup pre-print review for the leg reads STLs, the print plan and the FEA summary, and binds each source constant so any edit makes the review stale. It is hand-built freshness tracking between CAD, FEA and print.Verification · Agent failure · 1 report66
  4. 4The owner asked for status bars built from the real design records in place of run-on agent commentary. The board pulls FEA verdicts, gates, mass ledgers and print plans per subsystem, and the measurement sheets show 0 of 70 because nobody has measured anything yet.Verification · Agent failure · 1 report66

How it fails

  1. Agent failure4

Sourced from public community reports. Costs and delays on individual entries are modeled estimates, not measurements.