Nomiq (anand2532) errors

3 recurring problems engineers report in Nomiq (anand2532), ranked by impact.

#184 by errors trackedMCADECAD

Recurring Nomiq (anand2532) errors, by impact

  1. 1The team's own enclosure-to-PCB interface check caught two real misses: side-key plungers overlapping switch actuators by 0.35 mm, and a mic bore sitting 0.71 mm off the acoustic port.MCAD · Agent failure · 1 report74
  2. 2A custom PCB checker overestimated corner clearance by up to 0.4 mm because it did not sample Edge.Cuts arcs, back-side 3D models were double-flipped, and its own check reported 0 violations while KiCad DRC in CI still was not green.ECAD · Agent failure · 1 report66
  3. 3Preparing a KiCad board for a JLC pick-and-place line surfaced a MEMS microphone whose pads had no solder paste, and a hand-fitted display module that had to be removed from the BOM and placement files.ECAD · Agent failure · 1 report66

How it fails

  1. Agent failure3

Sourced from public community reports. Costs and delays on individual entries are modeled estimates, not measurements.