solidcore (tangency-labs) errors

3 recurring problems engineers report in solidcore (tangency-labs), ranked by impact.

#203 by errors trackedMCAD

Recurring solidcore (tangency-labs) errors, by impact

  1. 1Depending on union order and seam angle, a boolean drops a whole rod yet still reports OK with a clean check; with tubes, one order comes out 4592 mm3 too large and passes the check.MCAD · Agent failure · 1 report74
  2. 2A plate and cylinder union with the cylinder past the plate's free edge cannot be filleted with the SMLib kernel (status 1001 at every radius), while the same solid rounds fine with OCCT and exports valid STEP. The issue was written by the reporter's AI agent.MCAD · Agent failure · 1 report66
  3. 3A SolidWorks 2013 STEP file has an edge whose UV trim drifts up to 5.126 mm off the edge, and SolidCraft refuses the solid.MCAD · Agent failure · 1 report66

How it fails

  1. Agent failure3

Sourced from public community reports. Costs and delays on individual entries are modeled estimates, not measurements.