A site search for four bypass diodes listed hundreds of valid spots per diode, but placing the four it picked gave 13 shorts. Working back, the search had four separate geometry bugs: tracks were reduced to their endpoints so a 20 mm track across a site was invisible, and clearance was measured from the footprint center instead of the pads. Fixing only the first bug flipped the answer to zero valid sites, which was just as wrong. The final placement was checked by reading back the saved file and running DRC, which came out 0 shorts.

Wrong design output reported against balloon-fresh (felixfelix-bot)

balloon-fresh (felixfelix-bot)Electronics & PCBWrong design outputMedium confidence

What engineers report

A wrong design output reported against balloon-fresh (felixfelix-bot): produces incorrect geometry, routing, values or parts.

Recorded mode: validation / geometry

Analyst note

From the Grok pain-radar digests, Nov 13-14 2026 (Nov 13 10:41 AM ET through Nov 14 7:41 AM ET digests plus the Haitch editions). Verified live 2026-11-14: issue/PR read; title and state confirmed.

What it costs a team

Modeled annual cost

$30,000

For a team of 5

Prototype delay

3 days

Modeled schedule slip per occurrence

Time lost

240 min

Per engineer per month, about 1 incidents

How the cost is modeled

240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000

A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.

Engineering tools that address it

No engineering tool profile lists this error yet. Browse tools that connect to balloon-fresh (felixfelix-bot).

Evidence

  1. 1felixfelix-bot/balloon-fresh PR #575: feat(v11): stage 1 - four bypass diodes on F.Cu, 0 shorts, and the §1 site table was wronggithub.com

More recurring errors in balloon-fresh (felixfelix-bot)

See all 26 balloon-fresh (felixfelix-bot) errors

Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.