Open_Duck_Mini_v2 (aaltaay) errors
3 failures reported against Open_Duck_Mini_v2 (aaltaay), sorted by how they fail and ranked by impact.
#196 by errors trackedPLM & dataMechanicalElectronics & PCB
Recurring Open_Duck_Mini_v2 (aaltaay) errors, by impact
- 1A print-readiness pass on Open Duck Mini v2, done by an agent under the owner delegation, triaged all 137 issues and PRs across four upstream repos. It fixed doc contradictions, one of them a plus 1.3 accelerometer bias in the upstream sim loop, and made one netlist.yaml the single source for 224 pins and 118 conductors.PLM & data · Wrong design output · 1 report66
- 2A sitting-pose change to the Open Duck Mini v2 exposed a unit-conversion bug: axis_static divided metres by 1000 again, so shove torque came out as gravity torque alone. The polar-moment estimate used the farthest fibre at 23.6 mm against 15.3 mm true, a cable loop span sat one point off its crossings, and stop-load BLOCKERs (loads not converged, safety factors below 1.5) plus a BOM '$' column holding 'BLOCKER' stopped the totals scripts.Mechanical · Wrong design output · 1 report66
- 3Held over from the Nov 12 6:41 AM ET sweep, which was written but never sent. The robot's gate checklist says there is still no single installed model, the dock and charger board are missing from the print folder, netlist and BOM, and the BOM still buys the old chest pad.Electronics & PCB · Missing capability · 1 report66
How it fails
Sourced from public community reports. Costs and delays on individual entries are modeled estimates, not measurements.