A managed .kicad_dru clearance rule quietly replaced each zone's own authored clearance at refill. Every kicad-cli DRC with --refill-zones poured copper at the fab minimum, so one board went to JLC's DFM with a 0.1021 mm pour-to-pad gap where the design said 0.3 mm. The fab-floor rule was meant as a floor. KiCad treats custom rules as replacements.

Silent failure reported against kicad-tools (rjwalters)

kicad-tools (rjwalters)Electronics & PCBSilent failureMedium confidence

What engineers report

A silent failure reported against kicad-tools (rjwalters): reports success, or uses stale data, while the result is wrong or missing.

Recorded mode: agent / failure

Analyst note

From the Grok pain-radar digests, Nov 14-15 2026 (Nov 14 8:41 PM ET through Nov 15 1:41 AM ET digests plus the Haitch edition). Verified live 2026-11-15: issue/PR read; title and state confirmed.

What it costs a team

Modeled annual cost

$30,000

For a team of 5

Prototype delay

3 days

Modeled schedule slip per occurrence

Time lost

240 min

Per engineer per month, about 1 incidents

How the cost is modeled

240 min/month × 5 engineers × 12 months = 240 hours × $125/hour = $30,000

A modeled estimate with medium confidence. Swap in your own team size and loaded rate to size it for your team.

Engineering tools that address it

No engineering tool profile lists this error yet. Browse tools that connect to kicad-tools (rjwalters).

Evidence

  1. 1rjwalters/kicad-tools PR #8955: fix(dru): restore authored zone clearances the fab-floor rule replaced at refillgithub.com

More recurring errors in kicad-tools (rjwalters)

See all 68 kicad-tools (rjwalters) errors

Sourced from public community reports. Costs and delays are modeled estimates, not measurements. Know a better source or a fix? Tell us at hello@productflo.io.